EasyManuals Logo

Hitachi NT 65MA4 User Manual

Hitachi NT 65MA4
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
English
After making the calculations as shown
above, you should nd a compressor
providing 4.9 CFM of air that is
required.
LUBRICATION
It is important that the Nailer be properly
lubricated.
Without proper lubrication, the Nailer will not
work properly and parts will wear prematurely.
Use Hitachi pneumatic tool lubricant.
Do not use detergent oil or additives.
These lubricants will harm the O-rings
and other rubber parts. This will cause the
Nailer to malfunction.
Filter-regulator-lubricator units should
always be used.
Keep the lubricator lled with Hitachi
pneumatic tool lubricant.
If a lubricator is not available, supply 5 – 10
drops of Hitachi pneumatic tool lubricant
into the air plug on the Nailer twice a day.
COLD WEATHER CARE
Do not store the Nailer in a cold weather
environment. ....Keep the Nailer in a warm
area until beginning the work.
If the Nailer is already cold, bring it in a
warm area and allow the Nailer to warm up
before use.
1 Reduce the air pressure to 64 psi (4.4
bar 4.5 kgf/cm
2
).
2 Remove all nails from the Nailer.
3 Connect the air hose and free- re
(blank- re) the Nailer.
The lowered air pressure will be
enough to free- re the Nailer.
Slow speed operation tends to warm
up the moving part.
CAUTION
Do not free- re the Nailer at high
pressure.
TESTING THE NAILER
DANGER
Operators and
others in work
area MUST wear
safety glasses
with side shields
which conforms
to ANSI Z87.1
speci cations.
WARNING
Never use Nailer unless push lever
is operating properly.
Before actually beginning the nailing work,
test the Nailer by using the check list below.
Conduct the tests in the following order.
If abnormal operation occurs, stop using
the Nailer and contact a Hitachi authorized
service center immediately.
(1) Disconnect air hose from nailer.
Remove all nails from nailer.
All crews must be tightened.
If any screws are loose, tighten them.
The push lever and trigger must move
smoothly.
Trigger
Push
Lever
Do not connect
air hose
000BookNT65MA4(S)US.indb11000BookNT65MA4(S)US.indb11 2013/03/279:04:032013/03/279:04:03

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi NT 65MA4 and is the answer not in the manual?

Hitachi NT 65MA4 Specifications

General IconGeneral
BrandHitachi
ModelNT 65MA4
CategoryNail Gun
LanguageEnglish

Related product manuals