English
16
5. Do not point the hot wind directly at people or animals. Do not look into the nozzle.
Do not use it as a hair dryer under any circumstances.
Failure to observe this may result in accidents or injury.
6. There are cases in which highly toxic gas will be emitted if used on plastic, lacquer
or similar materials.
Always ensure that the work area is fully ventilated, and wear a dust-protection
mask.
7. Apply heat gently while moving the Heat Gun up, down, left and right.
Aiming it constantly at a single location may result in the outbreak of smoke or fi re.
8. Check the tool for damage, cracks or malformation in the event of it being
accidently dropped or subject to impact.
Damage, cracks and malformation may result in injury.
9. Cease operations immediately in the event of the tool not operating properly or
if abnormal noises or vibrations are noticed, and contact a Hitachi Authorized
Service Center to request inspections and repairs.
Continued use may result in injury.
10. Do not get away from the unit while it is switched on. Failure to observe this may
result in accidents.
CAUTION
1. Parts of the nozzle supplied are sharp, so use gloves when removing them from the
case and when attaching or detaching them.
2. The hot wind release nozzle, the tip of the nozzle and the material that was heated
are extremely hot during and immediately after using the tool, so use gloves and
avoid touching them directly.
3. Do not use inside boxes, drawers or other enclosed spaces.
Aiming it constantly at a single location may result in the outbreak of smoke or fi re.
4. Make sure the nozzle is at least 5cm away from the item being heated when using
the tool. Also, do not cover or otherwise block the nozzle.
Failure to observe this may result in the Heat Gun overheating, leading to
malfunctions.
5. Do not switch the tool on and off repeatedly. Also, do not use the tool with the
power cord folded or twisted.
Failure to observe this may result in malfunctions.
6. Do not point the heat-wind release nozzle downwards immediately after use.
Failure to observe this may result in the tool overheating, leading to malfunctions.
7. Make sure that the Heat Gun has cooled completely before storing it away.
Failure to observe this may result in burns or malformation of the storage case.
SYMBOL
WARNING
The following show symbols used for the machine. Be sure that you understand their
meaning before use.
To reduce the risk of injury, user must read instruction manual.
000BookRH600TChS.indb16000BookRH600TChS.indb16 2016/07/1913:49:422016/07/1913:49:42
To Next Page
Loading...
Need help?
General
