QUICK START GUIDE
HITRON
CGNV5
Check the contents of the box
Make sure you have the following:
Connect to the internet
Connect phone
Connect the coaxial cable to the connector
Connect the coaxial cable from the cable outlet to the
connector of the device.
Connect the power adaptor to the power port and switch to
“ON”.
Connect the phone to the voice port
Connect your computer to the device
Use the phone cord to connec ypur phone to the Voice Port and
wait for a dial tone before using.
Use the Ethernet cable that comes with the device to connect
your computer to one of the LAN ports
User configuration (optional)
Connect your computer to the wireless network
Your device has a configuration interface that allows you to
fully control the behavior of the device. In a web browser,
enter the IP of the device in the address bar and make sure
that your PC is on the same subnet as deice. On the screen
that appears, enter the username and password.
Contraseña: #BBAADD@CCFFEE*
IP del dispositivo:
Modo Router: 192.168.1.1
Mode Bridge: 192.168.100.1
Connect the wireless devices with the correct SSID and password.
If they have not been changed, the default values are indicated on
the sticker on the back of the equipment.
Connect your wireless devise with WPS unction. Enter the setting interface
(refer to step 6), Enter the Wireless page to
Enable WPS and set the AES encryption mode,
then press Save changes.
Press this button to start the WPS Push Button
(PBC) setup process. Press on the PBC button of
your wireless clients within the coverage area
within the two minutes allowed to join the
wireless network.
To Next Page
Need help?
General
