7 8
Visor(Shield) Cleaning
The helmet visor(shield) is made of polycarbonate materials with a polyurethane abrasion resistance
coating. It should be cleaned using mild soap and warm water. Never use hot water, salt water, benzene,
thinner, gasoline or any other harsh agents. Additionally the use of commercial visor(shield) cleaners is not
recommended because they may affect the quality of the visor(shield) material. Treat carefully when
cleaning the visor(shield) to preserve the abrasion resistant coating. When deep scratches are visible,
it is highly recommended that the helmet visor(shield) be replaced. Tinted visor(shield) are for “Day time
use only” and are not suitable for use at night or in conditions of poor visibility.
Cheek Pad Removal
There are 3 snaps holding the cheek pad in place.
1. Gently pry the check pad away from the interior, releasing the snaps.
2. Grasp the cheek pad near its center and gently pull it free from the chin strap.
Visor(Shield) Installation
Visor(Shield) Removal
1. Press the visor(shield) locker, then lift the visor(shield) tab up.
2. Open visor(shield) to the maximum open position.
3. Pull the handle-locker to the open position, then pull out the visor(shield) from ratchet mechanism.
1. Ensure that the handle-locker is in the open position.
2. Align and insert the top of the visor(shield) guide into the plate-gear guide.
3. With the guides properly aligned, press the lower section of the visor(shield) into the plate-gear
mechanism. The locking tab should pop into position, locking the visor(shield) into place.
1 2
1
Visor(shield) locker
Visor(shield) tab
2
1
Handle-locker
OPEN
2
3
3
OPEN
Handle-locker
Cheek Pad Installation
1. Feed the chin strap through the opening in the cheek pad.
2. Align and fully slide the cheek pad plastic plate between shell and EPS.
3. Clip the cheek pad’s 3 small male snaps to the 3 female snaps fixed on the shell interior.
1
3
※Slide tab 'A' from the cheek pad into the holder 'B'.
(Repeat same on opposite side)
B
A
Position of tap holder
B
A
Always check to make sure helmet pads are installed before using the helmet. A helmet
with missing or improperly installed pads may increase your risk of serious injury or
death in an accident.
To Next Page
Loading...
Need help?
General
