1. Begin by gently pulling the plastic sleeve from the right side.
(Repeat on the opposite side.)
1. Align and snap the plastic sleeves on each side.
When helmets left out in the sun for extended periods of time, it may fade overtime.
Breath Deflector Removal
1. Push breath deflector flat and pull away from the helmet as arrows indicate.
Breath Deflector Installation
1. Push breath deflector into specified slot as arrows indicate.
Crown Pad Installation
1. Install the front section first by aligning the plastic shell base and the crown pad plastic sleeve, ensuring that the center
and side holes are properly aligned. Press the crown pad plastic sleeve (center portion) into the center of the channel
which is built into the plasticshell base, working your way outward to each side.
2. Align and snap the two rear snaps into place.
To Next Page
Loading...
Need help?
General
