1. Pull the shield forward slightly then lift all the way up.
2. Move the handle-locker to the open position.
3. The shield will be automatically released out of the base ratchet mechanism.
1
2
OPEN
OPEN
Handle-locker
1. Grasp the crown pad fabric as close as possible to its plastic base and pull/pry away from the helmet.
Notice how the crown pad plastic section aligns with the shell plastic sleeve. This will help orient you
with the reinstallation.
2. Repeat same at rear.
1. Install the front section first by aligning the plastic shell base and the crown pad plastic sleeve, ensuring
that the center and side holes are properly aligned. Press the crown pad plastic sleeve (center portion)
into the center of the channel which is built into the plasticshell base, working your way outward to each
side.
2. Align and snap the two rear snaps into place.
To Next Page
Loading...
Need help?
General
