HJC RPHA 31 User Manual

3 4
1. After pushing the lower left part of the visor(shield) outward, lift the visor(shield) to the top.
2. Pull the handle-locker to the open position, then pull out the visor(shield) from ratchet mechanism.
1. Ensure that the handle-locker is in the open position.
2. Align and insert the top of the visor(shield) guide into the plate-gear guide.
3. With the guides properly aligned, press the lower section of the visor(shield) into the plate-gear
mechanism. The locking tab should pop into position, locking the visor(shield) into place.
Visor(Shield) Installation
Always check to make sure helmet pads are installed before using the helmet. A helmet with
missing or improperly installed pads may increase your risk of serious injury or death in an accident.
Visor(Shield) Removal
Warning!
1. Grasp the crown pad fabric as close as possible to its plastic base and pull/pry away from the helmet.
Notice how the crown pad plastic section aligns with the shell plastic sleeve. This will help orient you
with the reinstallation.
2. Repeat same at rear.
Crown Pad Removal
2
When lowered, the Visor(Shield) Deector reduces the wind coming under the chin.
Visor(Shield) Deector Raised Position Visor(Shield) Deector Lowered Position
Visor(Shield) Deector Operation
1
2
OPEN
OPEN
Handle-locker
Handle-locker
1
OPEN
OPEN
Handle-locker
Handle-locker
3
After pushing the lower left part
of the visor (shield) outward,
lift the visor to the top.
Visor(Shield) Operation
1a 1b

HJC RPHA 31 Specifications

General

Brand	HJC
Model	RPHA 31
Category	Motorcycle Accessories
Language	English