03-10
3.7 Locking brake
facilities
The components of the brake facilities are co-
vered in the general operation permission docu-
ments. If you alter or modify any components of
the brake facilities, the operation permission lo-
ses its validity. Modications may only be made
with the manufacturer's permission.
Parking the carriage
When parking the carriage, the locking brake of
the camper must be activated.
To lock
• Pull the locking brake lever upward by the
handle (1) until it locks into place. The locking
brake lever is pressed into the nal position
by the gas pressure spring.
To release
• Press the locking brake lever back into the
original position.
1
When entering and exiting the vehicle:
•
Place step tread in front of the entry door to
the camper.
• Ensure that the step tread is placed on a
level surface; this prevents the step
tread from falling over.
Note the varied tread heights and,
when exiting, ensure you will step
onto rm and even ground.
3.6 Entry step tread
To Next Page
Loading...
Need help?
General
