7
OPERATION
The FAN may be operated by the manual controls located on the FAN or by your remote
control ( Fig. 8 & 9).
1.Place the FAN on a stable flat surface. Plug the cord set into a 220-240V~ electrical
outlet. Plug on the FAN, existing room temperature will be displayed at LED display.
2.POWER : Turn the FAN on by pressing the ‘POWER’ button; Turn the FAN off by
pressing the ‘POWER’ button again.
3.SPEED : You can adjust the fan speed to the desired level: low, medium, or high
by pressing ‘ ’. The speed setting is displayed on the LED display. (Fig. 10)
4.MODE : Pressing the ‘ ’button will set the FAN into NORMAL, NATURAL,
SLEEP and CHILD mode.
- NORMAL Mode: Fan will start work at any speed you set up.
- NATURAL Mode : Fan will start work at low speed(5s)→medium speed(5s)→high
speed(5s)→medium speed(5s), it works as per this recycle.
- SLEEP Mode : 1) If you set the fan at high speed, fan will work at high speed at 30
mins, then the fan will transfer to medium speed and work at 30 mins, later the fan
transfer to low speed and keep working until the fan stop working.
2) If you set the mode at medium speed, fan will work at medium speed at 30 mins, then
the fan will transfer to low speed and keep working until it stop working.
3) If you set the mode at low speed, fan will work at low speed until the fan stop working.
The LED display will turn off if you don’t control the fan in 30 seconds, touch any button
to turn on the display.
- CHILD Mode : Fan will auto. Set up timer at 3 hours and oscillation function will
start. The fan will work at high speed for 15 minutes, and it will transfer to medium speed
at 15 minutes, then it will transfer to low speed until it take off. You can take off
“oscillation function” manually. The LED display will turn off if you don’t control the fan in
30 seconds, touch any button to turn on the display.
5. TIMER : The fan is equipped with a timer that allows you to set its length of
operation from 1 hour to 12 hours. The LED display will turn off if you don’t control the
fan in 30 seconds, touch any button to turn on the display.
6. OSCILLATION : Pressing the ‘ ’ button will start and stop the oscillation
function. The symbol is displayed on the LED display.
7. COOLING : Press ‘ ’ button to turn on the cold air function. Press button again
to turn off. If you want to operate the unit with water for better cooling, pull out the
water tank and fill it up to the MAX mark at the most. Take care when doing so, to
make sure, that no water enters the product, e.g. through the air inlet.
To Next Page
Loading...
Need help?
General
