Fuse Replacement
One of the two fuse boxes in your car is located under the
dashboard on the driver's side. The circuits protected by each fuse
are listed inside the fuse box cover. To open the fuse box, turn the
knob as shown.
If any of your car's lights, accessories, or controls don't work,
check their fuses. If a fuse has blown, the wire inside it will be
burned through.
Checking the fuses:
1. Turn off the ignition and all other switches.
2. If you find a blown or possibly faulty fuse, use the fuse remover,
stored beside the spare fuse to pull the blown fuse out of its clips.
3. Check all other fuses as well as the one you suspect.
4. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips. If it fits loosely, have your dealer fix it.
If you don't have a spare, take a fuse of the same rating (or lower)
out of a circuit you may not need, like the radio or cigarette lighter.
Remember to replace the borrowed fuse and the missing spares.
(cont'd)
BLOWN
FUSE
REMOVER
To Next Page
Loading...
Need help?
General
