Child Safety
Using Child Restraints with
Tethers
Your Honda is equipped with an
attachment point for a child
restraint system that uses a top
tether. The tether attachment
point is located on the panel behind
the passenger's seat-back.
1. Adjust the passenger's seat fully
forward to make room behind
the seat-back.
2. Remove the plug with a small
flat-tipped screw driver or
fingernail file.
3. Install the tether hardware that
came with the child seat.
Tighten to:
2
2
N.m (2.2 kg-m , 16 Ib-ft)
Make sure to route the tether
through the space between the
head restraint and seat.
If you are not sure how to install
the bracket, have it installed by
your Honda dealer.
If you need an anchor plate and
mounting hardware, you can obtain
them by writing to:
American Honda Motor Co., Inc.
Consumer Affairs
1919 Torrance Blvd.
Torrance, CA 90501-2746
Driver and Passenger Safety
To Next Page
Loading...
Need help?
General
