−
−
−
Turn Signal
Off
Parking and interior lights
Headlight on
High beams
Flashhighbeams
Push down on the
left lever to signal a left turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever and
hold it. The lever will return to
center when you release it or
complete a turn.
Rotating the
switch on the left lever to the
‘‘ ’’ position turns on the parking
lights, taillights, instrument panel
lights, side-marker lights, and rear
license plate lights. Turning the
switch to the ‘‘ ’’ position turns
on the headlights. If you leave the
lights on with the key removed from
the ignition switch, you will hear a
reminder tone when you open the
driver’s door.
To turn on, push
the lever forward until you hear a
click. The blue high beam indicator
will come on (see page ). Pull it
back to return to low beams. To
flash the high beams, pull the lever
back lightly, then release it. The
high beams will stay on as long as
youholdtheleverback.
With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
off, even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
1.
2.
3.
4.
5.
6.
42
Turn Signal, Headlights
Instruments and Controls
Turn Signal and Headlights Turn Signal
Headlights On
High Beams
Daytime Running Lights
(Canadian Models)
48
To Next Page
Loading...
Need help?
General
