Wait a few minutes after turning the
engine off before you check the oil.
Remove the dipstick again, and
check the level. It should be
between the upper and lower
marks.
If it is near or below the lower mark,
see on page .
Remove the dipstick (orange loop).
Wipe off the dipstick with a clean
cloth or paper towel.
Insert the dipstick all the way back
into its hole.
Holding the grip, pull the support
rod out of its clip. Insert the end
into the designated hole in the
hood.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
1.
2.
3.
3. 4.
177
Oil Check
Adding Engine Oil
Service Station Procedures
Before Driving
135
SUPPORT ROD
UPPER MARK
LOWER MARK
DIPSTICK
CLIP
GRIP
０５／１２／２１ １６：５３：５８ ３１ＳＡＡ６００ ０１３８
To Next Page
Loading...
Need help?
General
