Turn on the fog lights to test the
new bulb.
Align the two tabs on the fog light
assembly with the holes in the
bumper, then push the fog light
assembly into place. Tighten the
screw securely.
Remove the bulb by turning it one-
quarter turn counterclockwise.
Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
Push the electrical connector onto
the bulb. Make sure it is on all the
way.
If your seat belts get dirty, use a soft
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air dry before
you use the vehicle.
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.
6.
7.
3.
4.
5.
Lights, Cleaning the Seat Belts
Cleaning the Seat Belts
Maintenance
319
TAB
TAB
CONNECTOR
BULB
LOOP
０８／０７／０９ １２：１８：０２ ３１ＳＮＡ６３０ ０３２４
To Next Page
Loading...
Need help?
General
