Honda CTX700N 2014 User Manual

Maintenance Fundamentals
61
continued
Maintenance
Also inspect the front sprocket and rear wheel
sprocket. If either has worn or damaged teeth,
have the sprocket replaced by your dealer.
❙
Cleaning and Lubricating
After inspecting the slack, clean the chain and
sprockets while rotating the rear wheel. Use dry
cloth with chain cleaner designed specifically
for O-ring chains, or neutral detergent. Use a
soft brush if the chain is dirty.
After cleaning, wipe dry and lubricate with a
lubricant designed specifically for use on O-ring
chains.
NOTICE
Use of a new chain with worn sprockets will cause rapid
chain wear.
Normal
(GOOD)
Worn
(REPLACE)
Damaged
(REPLACE)
Recommended lubricant:
Pro Honda HP Chain Lube or equivalent chain lube

Honda CTX700N 2014 Specifications

General

Engine Type	670cc liquid-cooled parallel-twin
Bore x Stroke	73.0mm x 80.0mm
Compression Ratio	10.7:1
Induction	PGM-FI with 36mm throttle body
Ignition	Digital transistorized with electronic advance
Transmission	Six-speed
Final Drive	Chain
Front Brake	Single 320mm disc with two-piston caliper
Rear Brake	Single 240mm disc with single-piston caliper
Front Tire	120/70-17
Rear Tire	160/60-17
Seat Height	28.3 inches
Fuel Capacity	3.17 gallons
Curb Weight	478 pounds
Front Suspension	41mm fork; 4.3 inches travel
Rear Suspension	Pro-Link single shock, 4.3 inches travel
Trail	4.3 inches