Honda EG5500CXS User Manual

CYLINDER BLOCK
14-6
PISTON DISASSEMBLY/ASSEMBLY
Remove the piston(page 14-4).
PISTON PIN CLIP
CUTOUT
END GAP
PISTON
ASSEMBLY:
Set the connecting rod upper with
the long end toward the mark on
the piston head.
LONG END
OIL RING
(COMBINATION
RING)
PISTON RING SET
TOP RING
SECOND RING
OIL RING
PISTON PIN CLIP (2)
PISTON PIN
MAKER MARK
10 mm (0.4 in)
120°
120°
120°
ASSEMBLY:
Be sure that the top ring and second ring are
not interchanged.
Install the top ring and second ring on the
piston with the maker mark side facing up.
Check that the piston rings rotate smoothly
after installing them.
Space the piston ring end gaps 120 degrees
apart, and do not align the ring end gaps with
the piston pin bore.
10 mm (0.4 in)
PISTON
ASSEMBLY:
Install by setting one end of the piston pin
clip in the groove of the piston pin bore,
holding the other end with long needle
pliers, and rotating the clip in.
Do not align the end gap of the piston pin
clip with the cutout of the piston pin bore.
MARK
CONNECTING ROD UPPER
SIDE RAIL
SPACER
TOP RING
SECOND RING
SIDE RAIL
82Z30000.book 6 ページ ２０１０年６月２５日 金曜日 午後５時５０分

Honda EG5500CXS Specifications

General

Brand	Honda
Model	EG5500CXS
Category	Portable Generator
Language	English