Honda HHT35S User Manual

50
TRANSPORTING
BEFORE LOADING
If the engine has been running, allow it to cool for
at least 15 minutes before loading the trimmer on
the transport vehicle. A hot engine and exhaust
system can burn you and can ignite some
materials.
Always turn the ignition switch to the STOP (O)
position. Make sure the fuel cap is securely
tightened.
LOADING
The trimmer may be secured by suitable clamps,
hangers or straps. Secure the trimmer by at least
two points along the frame pipe. Avoid securing
the trimmer by the engine, cutting head/gear
case or handle area. The trimmer should be
secured in a horizontal position, with the engine
upright as shown.
Don't hang the trimmer by the gear case or
cutting head, or they may be damaged.

Honda HHT35S Specifications

General

Displacement	35.8 cc
Fuel Type	Unleaded Gasoline
Handle Type	Loop
Cutting Head	Semi-matic (bump feed)
Fuel Tank Capacity	0.17 gallons
Power Output	1.3 HP
Cutting Width	17 inches
Engine	4-stroke
Shaft Type	Straight shaft
Weight	15 lbs