– 40 –
Speed Key (Macros) (cont’d)
Executing
To execute a Speed Key sequence, do the following:
If a lettered key, A-B-C, has been assigned as a Speed Key, press and hold
down the appropriate key (about 2 seconds). If a user code is required for any
part of the Speed Key sequence, the following prompt appears. Otherwise,
the Speed Key sequence automatically begins.
ENTER USER CODE
7777
Enter your user code. The defined Speed Key sequence will begin
automatically.
To activate a Speed Key not assigned to the A-B-C keys, press and hold down
the [D] key for 2 seconds until the following prompt appears:
ENTER SPEED KEY #
01-32 00=QUIT
Enter the desired Speed Key number.
If a user code is required for any part of the Speed Key sequence, the
following prompt appears. Otherwise, the Speed Key sequence automatically
begins.
ENTER USER CODE
7777
Enter your user code. The programmed Speed Key sequence will begin
automatically.
Using Speed Key For Fire Alarm Function
Instead of a macro sequence, the Speed Keys can be programmed for the
following fire alarm functions:
• Fire Sounder Silence - The key, when pressed, silences fire alarms.
• Display Next Fire Alarm - The key, when pressed, causes the keypad to
display the next fire alarm in the system.
• Display Previous Fire Alarm - The key, when pressed, causes the keypad
to display the previous fire alarm in the system.
NOTE: Each of these functions requires programming by the installer. If you
want to use a Speed Key for one of these functions, ask your installer to
program the system accordingly.
To Next Page
Loading...
Need help?
General
