Installation and Operations Guide
|
Initial firmware and operator workstation setup
© Honeywell. All Rights Reserved. LT-VLXEXPAXMIOG Rev. 01
45
3. Press Y, and then press Enter.
The VLX/ACM-VLX restarts.
4. Close HyperTerminal.
Using the Change Configuration menu
The Change Configuration menu enables you to set network and device
configurations. If necessary, you can make and save changes, disconnect power,
and the VLX will save the setup until the unit is powered up again.
IMPORTANT! Always configure ACM-VLX using Compass Device Manager.
Setting the Device Instance The device instance is item A on the Change
Configuration menu.
The device instance is a unique number throughout the BACnet internetwork
that identifies the device for BACnet communications. Valid range for the device
instance is 0 to 4,194,303. For more detailed information about device instances,
see the BACtalk System Design Guide (LTBT-TM-SYSDSGN).
Setting Ethernet options Ethernet network settings are items B, C, and D on
the Change Configuration menu. Select options according to Table 7.
See the BACtalk System Design Guide (LTBT-TM-SYSDSGN) for more
information about Ethernet and IP configurations.
Figure 23 The Change Configuration menu of the VLX Configuration &
Diagnos tic utility
To Next Page
Loading...
Need help?
General
