Model IFP-2100ECS
Basic Operating Instructions
These instructions must be framed and displayed next to the IFP-2100ECS panel in
accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems.
FS = Fire System ECS = Emergency Communication System
Operation Task to Perform
Silence Alarms
and Troubles
Press SILENCE then enter a code if prompted. Silence LED will light.
Reset Alarms
2.
Press 1 to Reset Fire System.
3.
Press 2 to Reset Emergency Communication. System.
Note: To reset ECS at an LOC, the user must gain ECS Control (See Figure 1).
View all active
alarms, troubles,
and supervisory
signals
The highest priority event will display first. Press the Down arrow to view location and type of alarm or trouble.
View a Point’s
Status
1.
Press ENTER to access Main Menu.
2.
Press 2 to select Point Functions.
3.
Then press 2 to select Point Status.
4.
Select the module the device is located on by using the Up or Down button. Then press ENTER.
5.
Enter the point number.
Conduct a Fire
Drill
Hold the DRILL button and then enter a code if prompted. OR
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Press 1 to select System Tests.
3.
Enter code if prompted, then press 1 to select Fire Drill.
4.
Press ENTER to start the fire drill, and Press ENTER to end the fire drill.
NOT APPROVED BY VERMONT FOR FIRE DRILLS.
To Next Page
Need help?
General
