3
Attach upper handle
Remove clean solution tank (upper
tank).
1-2
1-3
1-4
1-5
1-6
1-7
1-8
With cord hook to back of cleaner, push
upper handle down onto lower handle.
Push bolts into holes on front of handle.
If bolts will not go through hole easily
handle is not pushed completely down.
Place nuts in recessed areas on back
of handle. Hold each nut in place while
tightening each bolt securely with a
Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
When handle sections are completely
together, squeeze trigger (A) on upper
handle to snap trigger rod in place.
A
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
Press cord into cord clip on back of
handle.
Pull cord tight.
To Next Page
Loading...
Need help?
General
