Hoover HDS 555 M-80 User Manual (English)

To Next Page

To Previous Page

If the sink is 34 or hi

her from the floor, the excesswater in Unicou

le hoses

cannot be drained directl

into the sink. It will be necessar

to drain excess

water from hoses into a bowl or suitable container that is heldoutside and lower

than the sink.

Connect the cold water su

hose to a threaded 3/4

(

inch

)

connector and make sure that it is

fastened tightly in place.

If the water

es are new or have not been used for an extended

eriod of time, let the water

run to make sure that the water is clear and free of impurities. If this precaution is not taken,

there is a risk that the water inlet can get blocked and damage the appliance.

The water su

to the a

liance can also be connected to the house hot water line

(

centralized s

stem, heatin

stem

)

,as lon

as it does not exceed a tem

erature of 60 C.

In this case, the wash cycle time will be shortened by about 15 minutes and the wash

efficiency slightly reduced.

The connection must be made to the hot water line following the same procedures as those

for the connection to the cold water line.

DIMENSIONS(mm)

Connector of ModelⅡ

Insert the drain hose into a drain

e with a minimum diameter of 4 cm, or let it run into the sink, makin

sure to avoid bendin

or crimping it. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height

between 40 and 100cm and must not be immersed in water.

Max 1000mm

Min 400mm

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent

cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to

facilitate proper installation.

450

580

850

1135

Need help?

Do you have a question about the Hoover HDS 555 M-80 and is the answer not in the manual?

Hoover HDS 555 M-80 Specifications

General

Appliance placement	Freestanding
Number of place settings	12
Noise level	43 dB
Drying class	A
Energy efficiency class	A++
Delay Start	Yes
Half Load Option	Yes
Product size	Full-size
Water consumption per cycle	10 liters
Width	60 cm
Depth	60 cm
Height	85 cm
Water Consumption	10 liters
Drying System	Condenser
Dimensions (H x W x D)	85 x 60 x 60 cm