Hub (underside)
tray should never be restricted.
always be used during cooking.
c. All food and containers of food are always placed
breaks, contact your
nearest authorized service
center
.
Turntable Installation
Turntable shaft
The accessible surface
may be hot during
operation.
a. Never place the
enamel tray
upside down. The enamal
must
on the
enamel tray
for cooking.
d. If
enamel tray
cracks or
Enamel tray
Important
information about installing
•
•
•
•
•
Please observe the installation instructions provided and note that this appliance
should only be installed by a quali ed technician.
In case a new socket is needed, installation and cable connection must only be done
by a quali ed electrician. If the plug is no longer accessible following installation, a
pole disconnecting device must be present on the installation site with a contact gap
of at least 3 mm.
Adapters, multiway strips and extension cords must not be used. Overloading can
This appliance is NOT intended for use in a commercial environment.
The appliance is tted with a plug and must only be connected to a properly
installed earthed socket.
result in fire.
Placement
appliance can cause serious personal injury or death.
•
cient ventilation around the microwave oven. At the rear •
and sides keep at least 10 cm free.
Do not cover the air vents.•
The adjustable feet should not be removed.•
Do not place the microwave oven near a heat source.•
Transmitting and receiving equipment such as radios and televisions can affect the •
operation of the micr owave oven.
• Danger! Do not disassemble this appliance. Touching internal components of this
Place the microwave oven on a firm,flat surface.
Make sure that there is surfi
GB
b. The
enamal tray
To Next Page
Loading...
Need help?
General
