User checklist
If your cleaner is not working properly run through the
following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with fine dust?
To empty the dust container see instructions on P6.
3. Is the hose blocked?
To clear a blockage see instructions on P7.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P7.
5. Are the filters blocked?
To clean filters, see the instruction on P6.
6. Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p4.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on p7.
8. Has the cleaner overheated? If so, it will take about 30
minutes to reset.
If there is any doubt call your local Hoover Service Office for advice. They
may be able to assist you over the telephone.
Aservice charge will be made if the cleaner is examined and found to be in
working order, has not been assembled in
accordance with these instructions or has been used
incorrectly.
WARNING
A thermal cut out switches off the cleaner to prevent over-
heating if it is used when full or there is a blackage or dirty
filters. If this should happen switch off, unplug and correct
the fault.
It will take approximately 30minutes for the cut out to auto-
matically reset.
IMPORTANT
DO NOT RUN OVER THE POWER SUPPLY CORD
AS THIS COULD DAMAGE THE SUPPLY CORD
INSULATION.
- 9 -
To Next Page
Loading...
Need help?
General
