Use the following to identify the parts and
features of the cleaner:
1. Turbine nozzle
2. Bag lid
3. Bag lid latch (on rear of cleaner)
4. Combination tool
5. Wand storage/tool storage slot (at rear of
carrying handle)
6. Crevice tool
7. Dusting brush
8. Wand/tool storage holder: fits into storage slot on
rear of carry handle
9. Suction regulator: use thumb to push open or closed
10. Hand grip
11. Hose
12. Wand grip
13. Carrying handle
14. Hose connector
15. ON/OFF switch
16. Telescoping extension wand: used with turbine
nozzle, floor brush or tools. Adjusts to desired length.
Operate cleaner only at voltage specified on data plate
on underside of the cleaner.
This cleaner is intended for household use.
5
B
C
1
2
3
5
8
9
6
7
4
10
11
12
13
14
15
16
A
Attach hose
Insert hose connector (A) into opening (B) in bag lid, align-
ing tabs on hose connector with slots in opening. Twist
counterclockwise to latch.
To remove hose, twist hose connector clockwise and pull
up.
Attach wand
To attach wand to hose, push wand firmly onto hose; twist
wand to tighten.
Adjust the telescoping wand to the desired length by push-
ing forward on the wand grip. Release grip to lock the
wand into position.
Attach tools and nozzle
To attach tool to the hose or wand, firmly push tool onto
hose or wand. Twist tool slightly to tighten or loosen con-
nection.
To attach either nozzle to the wand, push the nozzle firmly
onto the wand. Twist nozzle slightly to tighten or loosen
connection.
1-3
1-4
2-1
1-2
Attach hose, wand, tools and nozzle
Cleaner description
2. How to use
(Cont’d)
→
To Next Page
Loading...
Need help?
General
