9
Remove brush roll cover (C) by removing the
3 Phillips head screws.
C
Lift off brush roll cover (C).
3-12
C
If belt is not broken but is stretched or cut,
pull it off the motor pulley (D).
3-13
D
3-11
Position hood on top of nozzle base.
Turn nozzle over. Replace 2 short screws at
the back of nozzle and 2 long screws at the
front.
Replace brush roll cover over agitator brush
roll. Replace 3 short screws.
Lift up end of agitator brush roll. Remove old
belt from agitator pulley (E) and replace with
new belt. Lettering on belt must be visible.
Stretch belt back and attach to motor pulley.
Hold opposite end of agitator brush roll in
place. Push belt end forward, rotating end
plate (F) until it slides into place. Turn agitator,
making sure it rotates freely.
3-14
3-15
3-17
E
F
C
3-16
To Next Page
Loading...
Need help?
General
