EMPTYING THE DUST CONTAINER
Hold the container over
the Bin and press the
easy open button at the
rear of the container.
The dust container door
will open and you can
empty into a bin with no
dust contact.
Once emptied, gently tap
or shake the container to
release any excess dust
from the filters.
Do not overfill the bin
above the max level line.
2
43
To remove the dust container from the
cleaner press the bin release button.
1
CLEANING THE PRE MOTOR FILTERS
Rotate the upper part of the dust bin to open.
1
Remove the lter assembly from the bin top by
rotating the lter. It is advisable to wash the lters
after every 5 bin empties.
2
Remove the protective lter mesh from
the HEPA lter, then gently tap both
lters to release any excess dust.
3
Wash both lter and protective mesh under warm
water until the water runs clean. Remove excess
water by shaking and leave to dry for 24 hours.
Reassemble and ret lters to cleaner, only when
they are completely dry.
4
CLEANING THE EXHAUST FILTER
The exhaust filter should be washed every month.
Press down on the latch to remove the exhaust cover.
Remove filter and wash with warm water.
Remove excess water by shaking and leave to dry for
24 hours. Refit filters only when completely dry.
!
IMPORTANT! Ensure the protective mesh is
reassembled to the HEPA lter before use
- 6 -
To Next Page
Loading...
Need help?
General
