If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
A WARNINGA
To reduce risk of personal injury - unplug vacuum before servicing.
PROBLEM POSSIBLECAUSE POSSIBLESOLUTION
vacuumwon't
run
System Check
Indicator has
turned red
or
Vacuum won't
pick up
or
Low suction
Dust escaping
from vacuum
Powered Hand
Tool brushrell
won't turn
2. Blown fuse or tripped breaker.
1. Rinsable Filter and/or HEPA
Filter is dirty.
3. Broken or worn Belt.
5. Carpet height setting is
incorrect.
2. Dirt Cup not installed correctly.
4. Rinsable and/or HEPA Filter
not installed completely.
2. Blockage.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
1.Clean Rinsable Filter and/or HEPA Filter -
Pg.9
3. Replace Belt - Pg.12.
5. Set Carpet Height Adjustment to appropriate
setting for carpet being cleaned - Pg.7.
2. Review Dirt Cup removal & replacement -
Pg. 8.
4. Review Filter Removal and Cleaning.
2. Remove blockage - Pg. 11
Smoky/burning 1. Belt broken or stretched. 1.Replace brushroll belt - Pg. 12.
smell detected
13
To Next Page
Loading...
Need help?
General
