How to Set the
Door Alarm
You don't have to set the visual
alarm. As long as either door is
open, the red DOOR OPEN signal
light flashes.
Why the Red Warm
Temperature Light Glows.
At first, it's probably because your
newly installed refrigerator hasn't
completely cooled down yet. Wait
a few hours for it to cool, and then
the light will go out.
How the Solid State
Monitor System Works.
If the signal light on the
DOOR ALARM pad is glowing,
the beeper alarm is set. If it's not,
touch the pad to turn it on.
From then on, the red light will
glow whenever temperatures inside
get too high for proper food storage.
If this happens, open the doors
only when absolutely necessao:,
and close them as quickly as
possible.
As soon as inside temperatures
return to normal, the light goes out.
The word NORMAL is lighted
except when a failure has been
detected.
If either door is open for more than
30 seconds, a recurring beep sounds.
The light goes out and the beeping
stops when you close the door.
There are times when you'll want
the Door Alarm beeper turned
off. When you're rearranging a lot
of 1hod, for exanrple. Jnst touch the
pad. The light will go out and the
beeping will stop.
Deactivating the Door Alarm
beeper does not turn the red DOOR
OPEN light oft" it keeps flashing
until the door is closed.
The STATUS CHECK-RESET pad
has two fnnctions:
1. You can touch the STATUS
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
2. You can touch the STATUS
CHECK-RESET pad to erase three
flashing codes immediately. Two
codes (DE and FF) cannot be erased
until the condition that caused them
to flash has been corrected (see
page 8).
(comi_medlwxtpage)
To Next Page
Loading...
Need help?
General
