Special wash cycles
and Options
Wash options
If an option is not compatible with the selected wash cycle
(see table of wash cycles), the corresponding LED/Symbol
flashes rapidly 3 times and beeps will sound.
Delayed start
The start of the wash cycle may be delayed for a period
of time between 1 and 12 hours.
1. Press the DELAYED START button: the corresponding symbol
appears on the display; each time you press the button, the time
(1h, 2h, etc. up to max. 12h) from the start of the selected wash
cycle will be increased.
2. Select the cycle and close the door: the timer will begin
counting down;
3. Once this time has elapsed, the indicator light switches off
and the wash cycle begins.
To adjust the delay time and select a smaller period of time,
press the DELAYED START button. To cancel it, press the button
repeatedly until the selected delayed start indicator light/symbol
switches off. The wash cycle will start automatically as soon as
the door is shut.
Multi-functional tablets
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button, the indicator light/symbol will
illuminate. The “Multi-functional tablets” option results in the
lengthening of the wash cycle.
The use of tablets is only recommended when the
MULTI-FUNCTIONAL TABLETS option is available.
This option is not recommended for use with wash
cycles which do not specify the use of multi-functional
tablets.
Extra drying
To improve the dryness level of the crockery, press
the EXTRA DRYING button, the indicator light/symbol will
illuminate. If it is pressed again the option will be deselected.
A higher temperature during the final rinse and an extended
drying phase allow for improving drying.
The EXTRA DRYING option increases the duration of
the wash cycle.
Zone Wash
This option makes it possible to carry out the wash cycle
in the selected rack only. Select the wash cycle and then press
the ZONE WASH button: the selected rack lights up and the wash
cycle starts in the selected rack only. Press the button again to
deselect the option.
The option is available with the following wash cycles: Intensive
and Normal.
Select the option and the Intensive cycle to start the
ULTRAINTENSIVE ZONE washing. This wash cycle is ideal
for very soiled mixed loads, e.g. pans and saucepans, dishes
with heavy encrustation or difficult-to-clean crockery (grater,
vegetable mill, dirty cutlery). The spraying pressure is stronger
and the washing temperature higher, thus ensuring optimum
handling of stubborn stains.
Select the option and the Normal cycle to start the SAVING
ZONE washing. This function makes it possible to reduce energy
consumption. Cycle duration might change.
Remember to load the crockery in the selected rack only
ACTIVE OXIGEN
This device releases ozone molecules into the dishwasher,
i.e. a natural substance that reduces unpleasant odours.
It should be used between two different wash cycles and ONLY
after soiled crockery has been loaded.
To start the ACTIVE OXYGEN option press and hold the button
O
3
. The option will stay active either for 24 hours or until the
wash cycle is started. More items can be introduced at any time
until full load.
The typical faint odour that can be smelt inside the dishwasher -
the same as you sometimes get with storms - is due to the ozone
produced by lightning discharges. This is normal. The device
produces just a small quantity, which soon decays.
No replacement needed.
* Only available in selected models.
Notes:
Optimum performance levels when using the “Fast wash”
and “Express 30’” cycles can be achieved by respecting
the specified number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative
EN testing conditions, please send an email to the following
address: ASSISTENZA_EN_LVS@indesitcompany.com
To Next Page
Loading...
Need help?
General
