Hotpoint MISTRAL FF72 User Manual

IMPORTANT INFORMATION:
€ Do not plug in and switch appliance on at the mains until installation is complete.
Door Reversal
If you need to change the door opening side, ensure doors function properly by following these
instructions. We recommend that whilst carrying out this conversion you place food into
insulated containers and remove all loose items/fittings from inside the door.
Remove Top Door
Note: You may reguire assistance for the removal and refitting of the top door.
1. Open door as wide as possible.
2. Support door, remove and retain screw securing the top right hinge (Fig 4).
3. Tilt door to release hinge from bracket, lift door off centre bracket and place to
one side.
4. Unscrew and remove top left hinge blanking piece, refit on top right side.
Remove Lower Door
5. Open door, raise slightly and pull out pin from centre bracket (Fig 5), retain pin and any
washers, lift door off bottom right hinge.
6. Unscrew, remove and retain bottom right hinge with plastic washers.
7. Place small end of foot adjustment tool in slot, twist as shown (Fig 6) and pull top of air
grille towards you to release blanking piece from left. Refit blanking piece on right and
refit air grille, pivot from bottom and push top forward until air grille clicks into place.
8. Refit hinge and washers to bottom left.
9. Using a blunt instrument, prise off the two plastic caps from the centre left of appliance,
remove screws, plastic inserts and retain.
10. Remove centre hinge bracket (Fig 7), washers and screws, refit on left.
Note: Insert screws and tighten only halfway, align and then tighten both screws securely.
11. Refit plastic inserts, screws and plastic caps on centre right.
Replace Lower Door
12. Remove hinge bush cap from top left of door and refit on top right.
13. Locate base of door onto bottom left hinge pin, align top left of door to centre hinge
bracket, locating hinge pin through centre hinge (Fig 5) into hinge bush.
14. Replace plastic washers on upper pin.
Replace Top Door
15. Remove hinge bush cap from top left of door and refit on top right, moving hinge to
top left.
16. Locate base of door onto centre left hinge pin, support door, align top left hinge to
bracket and secure with screw.
Note: Replace items/fittings, adjust feet to stabilise (see opposite) and let the appliance stand
upright in final location for at least 2 hours before plugging in and switching on the
` electricity supply.

Hotpoint MISTRAL FF72 Specifications

General

Brand	Hotpoint
Model	MISTRAL FF72
Category	Refrigerator
Language	English