HP 2600 Series User Manual

10-4
Traffic/Security Filters (ProCurve Series 2600/2600-PWR and 2800 Switches)
Using Source-Port Filters
Using Source-Port Filters
This feature is available only on the Series 2600, 2600-PWR, and 2800
switches.
Operating Rules for Source-Port Filters
■ You can configure one source-port filter for each physical port or port
trunk on the switch.
■ Each source-port filter you configure is composed of:
• One source port or port trunk (trk1, trk2, ...trk6)
• A set of destination ports and/or port trunks that includes all LAN
ports and port trunks on the switch
• An action for each destination port or port trunk
When you create a source-port filter, the switch automatically sets the
filter to forward traffic from the designated source to all destinations for
which you do not specifically configure a "drop" action. Thus, it is not
necessary to configure a source-port filter for traffic you want the switch
to forward unless the filter was previously configured to drop the desired
traffic.

HP 2600 Series Specifications

General

Brand	HP
Model	2600 Series
Category	Switch
Language	English