To Next Page

To Previous Page

Setting up the monitor

Installing the monitor stand

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of

color or disorientation of the liquid crystals. If this occurs, the screen will not recover to its normal condition.

1. Lay the display head face down on a at surface covered by a clean, dry cloth.

2. Attach the top of the stand arm (1) to the connector (2) on the back of the display panel. The stand arm

will click into place.

3. Slide the base (1) into the bottom of the stand arm until the center holes are aligned. Then tighten the

screw (2) on the underside of the base.

Connecting the cables

NOTE: The monitor ships with select cables. Not all cables shown in this section are included with the

monitor.

1. Place the monitor in a convenient, well-ventilated location near the computer.

Setting up the monitor 5

Questions and Answers:

Need help?

Do you have a question about the HP 27er and is the answer not in the manual?

HP 27er Specifications

General