EasyManuals Logo
Home>HP>Desktop>280 G1

HP 280 G1 User Manual

HP 280 G1
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Power LED flashes Red six times, once every second, followed by a two second pause, and the computer beeps six times. (Beeps
stop after fifth iteration but LEDs continue flashing.)
Cause Solution
Graphics card (some models) is not seated properly or is bad, or
system board is bad.
For systems with a graphics card:
1. Reseat the graphics card. Power on the system.
2. Replace the graphics card.
3. Replace the system board.
For systems with integrated graphics, replace the system board.
Power LED flashes Red ten times, once every second, followed by a two second pause, and the computer beeps ten times. (Beeps
stop after fifth iteration but LEDs continue flashing.)
Cause Solution
Bad option card. 1. Check each option card by removing the cards one at time (if
multiple cards), then power on the system to see if fault
goes away.
2. Once bad card is identified, remove and replace bad option
card.
3. Replace the system board.
Solving Network Problems
Some common causes and solutions for network problems are listed in the following table. These guidelines
do not discuss the process of debugging the network cabling.
Table 7-2 Solving Network Problems
Wake-on-LAN feature is not functioning.
Cause Solution
S5 Maximum Power Saving feature is enabled. Disable the S5 Maximum Power Saving option in Computer Setup.
Select Power > Hardware Power Management > S5 Maximum
Power Savings.
S5 Wake on LAN is disabled (some models). Enable the S5 Wake on LAN option in Computer Setup. Select
Advanced > Device Options > S5 Wake on LAN.
Wake-on-LAN is not enabled. To enable Wake-on-LAN in Windows 7:
1. Select Start > Control Panel > Network and Sharing Center.
2. Under Tasks, select Manage network connections.
3. Click Local Area Connection.
4. Click the Properties button.
5. Click the Configure button.
6. Click the Power Management tab, then select Allow this
device to wake the computer.
To enable Wake-on-LAN in Windows 8.1:
Solving Network Problems 83

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 280 G1 and is the answer not in the manual?

HP 280 G1 Specifications

General IconGeneral
Tcase72 °C
Bus typeDMI
SteppingC0
FSB ParityNo
Processor cache3 MB
Processor cores2
Processor modelG3250
System bus rate5 GT/s
Processor familyIntel Pentium G
Processor seriesIntel Pentium G3000 series for Desktop
Processor socketLGA 1150 (Socket H3)
Processor codenameHaswell
Number of QPI links0
Processor frequency3.2 GHz
Processor cache typeSmart Cache
Processor lithography22 nm
Processor manufacturerIntel
Processor front side bus- MHz
PCI Express slots version3.0
Processor operating modes64-bit
ECC supported by processorYes
PCI Express configurations1x16, 2x8, 1x8+2x4
Thermal Design Power (TDP)53 W
Number of processors installed1
Maximum number of PCI Express lanes16
Memory types supported by processorDDR3-SDRAM
Memory clock speeds supported by processor1333 MHz
Memory bandwidth supported by processor (max)21.3 GB/s
Maximum internal memory supported by processor32 GB
Operating system installedWindows 7 Professional
Chassis typeMicro Tower
Product colorBlack
Country of originChina
Memory slots2x DIMM
Internal memory4 GB
Memory channelsDual-channel
Memory clock speed1600 MHz
Maximum internal memory16 GB
Memory layout (slots x size)1 x 4 GB
HDD speed7200 RPM
HDD interfaceSATA
Storage mediaHDD
Optical drive typeDVD Super Multi
Card reader integrated-
Total storage capacity500 GB
Product typePC
Motherboard chipsetIntel® H81
Discrete graphics card modelNot available
On-board graphics card modelIntel® HD Graphics
Maximum on-board graphics card memory1.7 GB
On-board graphics card base frequency350 MHz
On-board graphics card DirectX version11.1
On-board graphics card dynamic frequency (max)1100 MHz
Number of displays supported (on-board graphics)3
Power supply180 W
Ethernet LAN data rates10, 1000, 100 Mbit/s
USB 2.0 ports quantity6
Scalability1S
Processor codeSR1K7
Processor ARK ID83538
Processor package size37.5 x 37.5 mm
Supported instruction setsSSE4.1, SSE4.2
Thermal solution specificationPCG 2013C
Intel Secure Key Technology version1.00
Intel Stable Image Platform Program (SIPP) version0.00
Weight and Dimensions IconWeight and Dimensions
Depth355 mm
Width165 mm
Height358.8 mm
Weight7050 g

Related product manuals