HP 3400A Service Manual

Installation Model 3400A
2-12. Adapter Frame (-hp- Part No. 5060-0797)
2-13. The adapter frame is a rack frame that accepts any combination of submodular units.
It can be rack mounted only. For additional information, address inquiries to your -hp-Sales
and Service Office.
2-14. REPACKAGING FOR SHIPMENT
2-15. The following paragraphs contain a general guide for repackaging for shipment. Refer
to paragraph 2-16 if the original container is to be used; 2-17 if it is not. If you have any
questions, contact your local -hp- Sales and Service Office.
NOTE
If the instrument is to be shipped to Hewlett-Packard for sérvice
or repair, attach a tag to the instrument identifying the owner and
indicate the service or repair to be accomplished; include the
model number and full serial number of the instrument. In any
correspondence, identify the instrument by model number, serial
number, and serial number prefix.
2-16. If original container is to be used, proceed as follows:
a. Place instrument in original container if available. If original container is not available,
one can be purchased from your nearest -hp- Sales and Service Office.
b. Ensure that the container is well sealed with strong tape or metal bands.
2-17. If original container is not to be used, proceed as follows:
a. Wrap instrument in heavy paper or plastic before placing in an inner container.
b. Use packing material around all sides of instrument and protect panel face with card-
board strips.
c. Place instrument and inner container in a heavy carton or wooden box and seal with
strong tape or metal bands. ‘
d. Mark shipping container with ‘‘DELICATE INSTRUMENT,” ‘‘FRAGILE,”’ etc.

HP 3400A Specifications

General

Brand	HP
Model	3400A
Category	Measuring Instruments
Language	English