4 HP 355/365 AP Wall Mount Kit | Installation Guide
Ethernet cable routing options
There are three options for routing the Ethernet cable, depending on the placement of
your AP in relation to the source of the Ethernet cable.
Installing an Ethernet cable from below the AP
1. Route the Ethernet cable through the channel in the rear of the mounting bracket.
See Figure 1.
2. Loop the Ethernet cable over the top of the mounting bracket, and direct the cable
through the opening that leads to the AP Ethernet ports.
3. If required, route the power cable through the bottom right of the mounting bracket.
4. Install the mounting bracket as described in Installing the mounting bracket on page 7.
To Next Page
Loading...
Need help?
General
