HP 48gx User Manual

Lesson 37: Adding and Using Libraries
A library is a collection of pre-programmed commands that act as
extensions to the built-in command set. The HP 48 does not have the
built-in capacity to create libraries, but it can install and use libraries
that have been created elsewhere (on other computers) and transferred
to the HP 48.
If you have an HP 48G model, you must download a library into
your machine using either the infrared port (from another HP 48) or
the serial port (from a personal computer). Refer to chapter 27 of
HP 48G Series User’s Guide for details about serial port transfer.
If you have an HP 48GX model, you have the additional option of
installing a plug-in card containing the library into one of the two
expansion card slots. Refer to chapter 28 of HP /8G Series User's
Guide for more details about plug-in cards.
Libraries, like any other object, can be placed on the stack or stored in
user memory. However, libraries cannot be used while stored on the
stack or in user memory.
To use a library, it must be:
m Stored in port memory (Port 0 for the HP 48G or Ports 0-32 for the
HP 48GX). All libraries that are distributed on plug-in cards are
already in port memory whenever the card is installed in its slot.
Libraries that are downloaded into the current directory must be
moved into port memory by you.
m Attached to a directory. Most libraries are self-attaching—that is,
they automatically attach themselves to the HOME directory as
soon as you turn on the HP 48 again after installing them in port
memory. Others will need to be explicitly attached by you.
To store a library into port memory manually:
1. Put the library object on the stack. (Note its number and name.)
2. Enter the port number for storing the library (0, 1, 2, ... 32).
3. Press (STO).
4. Optional: Purge the original library object from user memory.
Special Features 8-7

HP 48gx Specifications

General

Brand	HP
Model	48gx
Category	Calculator
Language	English