B
efore repairing connectors, follow these steps:
▲ Prepare the monitor for disassembly. See Preparation for disassembly on page 16.
VGA connector P100
524sf, 524sw, 524sh, 524sa, 527sf, 527sw, 527sh, 527sa
Repair the VGA connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You
can gently push down with the soldering iron once everything is molten to move the P100 out of the
through holes.
2
) Lift the P100 connector from the PCB..
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component
To Next Page
Loading...
Need help?
General
