HP 524sf User Manual

34
Screen is blank
or video is
flashing.
Power cord is disconnected. Connect the power cord.
Monitor is off. Power the power button.
NOTE: If pressing the Power button has
no effect, press and hold the power
button for 10 seconds to disable the
Power button lockout feature.
Video cable is improperly connected. Connect the video cable properly.
System is in Sleep mode. Press any key on the keyboard or move
the mouse to exit Sleep mode.
Video card is incompatible. Open
the OSD menu and select the Input
Control menu. Set Auto-Switch Input to
Off and manually select the input
Image appears
blurred,
indistinct, or too
dark.
Brightness is too low. Open the OSD menu and select
Brightness
to adjust the brightness scale
as needed.
Check Video
Cable
is
displayed on
screen.
Monitor video cable is disconnected. Connect the appropriate video signal
cable between the computer and
monitor. Be sure that the computer
power is off while you connect the video
cable.
Input Signal Out
of Range
is
displayed on
screen.
Video resolution and/or refresh rate are
set higher than what the monitor
supports.
Change the settings to a supported
setting.
The monitor is
off, but it did not
seem to enter
into Slee
p mode.
The monitor’s power saving control is
disabled.
Open the OSD menu and select
Power
Control > Auto-Sleep Mode
and set
auto-sleep to
On
.
On-Screen
Menus are
Locked
is
displayed.
The monitor’s OSD lock function is
enabled.
Press and hold the
Menu
button on the
front bezel to 10 seconds to disable the
OSD lockout function.
Power Button is
Locked
is
Displayed
The monitor’s power button is locked. Press and hold the power button for 10
seconds to disable the power button lock
function.

HP 524sf Specifications

General

Brand	HP
Model	524sf
Category	Monitor
Language	English