HP photosmart 715 user guide32
To connect the camera to a computer running Windows
1 Make sure that the camera is turned off.
2 Plug the smaller end of the USB cable into the camera.
3 Plug the other end of the cable into any USB port on the
computer.
Note When the camera is connected to a computer, only
the switch operates. The other camera
buttons do not respond.
Unloading images to a Windows computer
Unloading is the process of copying images from the CF memory
card in the camera to a computer.
You can unload images from your camera in one of three ways:
automatically, manually, or by mounting the camera as a disk
drive. The automatic unload procedure is the preferred method.
For descriptions of the other methods, see the online
documentation with the HP Photo Imaging software.
Tip To conserve battery power, use an HP-approved AC
adapter (optional) when you are unloading images
to a computer.
Follow the procedure in this section if your computer runs
Windows Me, Windows XP, Windows 2000, or Windows 98.
To unload images to a Windows computer
1 Connect the camera to the computer using the USB cable.
2 Turn on the camera.
HUG.book Page 32 Tuesday, September 25, 2001 1:03 PM
To Next Page
Loading...
Need help?
General
