Software Update and Recovery
Maintenance and Service Guide 3–11
1. Connect the computer to external power through the
AC adapter and turn on the computer.
2. Immediately insert the Operating System disc into the
computer.
3. Press and hold the power/standby button for at least 5 seconds
to turn off the computer.
4. Press the power/standby button again to turn on the computer.
5. When prompted, press any key to start from the disc.
After a few minutes, you may need to select your language,
and then the Setup Wizard opens.
✎
On the “Welcome to Setup” page, do not press R (step 8 in
this procedure) until you have completed steps 6 and 7.
6. Press enter to continue.
A licensing agreement page is displayed.
7. Press
f8 to accept the agreement and continue.
The “Setup” page is displayed.
8. Press
R to repair the selected Windows installation.
The repair process begins. This process takes 1 to 2 hours to
complete.
The computer restarts in Windows after the process is complete.
To Next Page
Loading...
Need help?
General
