Security menu
Select To do this
Setup password Enter, change, or delete a setup password.
Power-On password Enter, change, or delete a power-on password.
Password options
●
Enable/disable stringent security.
●
Enable/disable password requirement on computer
restart.
DriveLock passwords
●
Enable/disable DriveLock on any computer hard drive
and on optional MultiBay hard drives.
●
Change a DriveLock user password or master password.
NOTE: DriveLock settings are accessible only when
you enter Computer Setup by turning on (not
restarting) the computer.
Smart Card security Enable/disable support for smart card and Java™ Card power-
on authentication.
NOTE: Power-on authentication for smart cards is
supported only on computers with optional smart card
readers.
NOTE: You must have an administrator password to
change this setting.
TPM Embedded Security Enable/disable support for TPM (Trusted Platform Module)
Embedded Security, which protects the computer from
unauthorized access to owner functions available in
Embedded Security for ProtectTools. For more information,
refer to the ProtectTools online Help.
NOTE: You must have a setup password to change
this setting.
System IDs Enter user-defined computer asset tracking number and
ownership tag.
Disk Sanitizer Run Disk Sanitizer to destroy all existing data on the primary
hard drive. The following options are available:
●
Fast: Runs the Disk Sanitizer erase cycle once.
●
Optimum: Runs the Disk Sanitizer erase cycle 3 times.
●
Custom: Allows you to select the desired number of Disk
Sanitizer erase cycles from a list.
CAUTION: If you run Disk Sanitizer, the data on the
primary hard drive is destroyed permanently.
ENWW Security menu 5