Using the MEBx setup utility menus
NOTE: For more information on iAMT, see the Intel Web site at http://www.intel.com/vpro.
Intel ME Configuration
Select To do this
Intel ME State Control Disable/enable the management engine.
Intel ME Firmware Local Update Disable/enable local management of firmware updates.
LAN Controller Disable/enable the integrated network controller.
Intel ME Features Control Enable AMT or none.
Intel ME Power Control Configure the management engine power policies.
Intel AMT Configuration
Select To do this
Host Name Assign a host name to the computer.
TCP/IP Disable/enable network interface or DHCP (assigns an IP
address if DHCP has been disabled) or change the domain
name.
Provisioning Server Assign a Provisioning server address.
Provision Model Assign Enterprise or Small Business Intel AMT model.
Set PID and PPS Enter PID and PPS.
Un-Provision Reset the AMT configuration to factory defaults.
SOL/IDE-R Enable remote boot control to IDE floppy or CD-ROM and
assign a username and password.
Secure Firmware Update Enable or disable updating firmware remotely.
Set PRTC Set the real-time clock.
Idle Timeout Set a time-out value.
Change Intel ME Password
Select To do this
Change ME Password Change the password.
NOTE: The default password is admin.
8 Chapter 2 Using Intel Active Management Technology (select models only)