Camera module
Description Spare part number
Camera module 461875-001
Before removing the camera module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 37).
Remove the camera module:
1.
Turn the computer right-side up, with the front toward you.
2.
Open the computer as far as possible.
3. Remove the four rubber screw covers (1) and the four Phillips PM2.5×8.0 screws (2) that secure the
display bezel to the display assembly.
4. Flex the inside edges of the display bezel left and right sides (1) until the bezel disengages from the
display enclosure.
5. Flex the inside edge of the display bezel top edge (2) until the bezel disengages from the display
enclosure.
38 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General