Installing Optional USB Modules
There are three optional USB modules available from HP (sold separately):
●
(1) a webcam for live video functions
●
(2) a retail integrated fingerprint reader to add security identification functions
●
(3) a retail integrated dual-head magnetic stripe reader for card data read
Figure 2-2 Optional USB Modules
The USB modules can be installed on the top of the monitor, the bottom of the monitor, or on either
side of the monitor.
NOTE: If you are installing a webcam, HP recommends that you install it on top of the monitor for
proper video orientation.
Figure 2-3 USB Module Installation Locations
NOTE: These USB ports only support the USB modules listed above. They do not support optical
drives or hard drives.
The procedure for installing a USB module is the same for all modules. To install a USB module:
1. Place the monitor panel face down on a flat surface covered with a clean, dry cloth.
4 Chapter 2 Setting Up the Monitor