To Next Page

To Previous Page

2 Setting up your computer

WARNING! To reduce the risk of electrical shock or damage to your

equipment:

• Place the computer in a location away from water, dust, moisture, and soot.

These can increase the inside temperature, or can cause fire or electrocution.

• Do not disable the power cord grounding plug. The grounding plug is an

important safety feature.

• Plug the power cord in a grounded (earthed) outlet that is easily accessible at all

times.

• Disconnect power from the equipment by unplugging the power cord from the

electrical outlet. To prevent direct exposure to laser beam, do not try to open the

enclosure of the CD or DVD drives.

• The power supply is preset for the country/region in which you purchased your

computer. If you move, check the voltage requirements for your new location

before plugging the computer into an AC power outlet.

The computer may be heavy; be sure to use ergonomically correct lifting

procedures when moving the computer.

To reduce the risk of serious injury read the Safety & Comfort Guide. The guide is

located on the web at

http://www.hp.com/ergo.

1. Place the computer so that all ventilation openings are unobstructed and

cabling is not in a walkway or where it can be stepped on or damaged by

placing furniture on it.

2. Connect all power cords from the monitor, computer, and accessories to a

power surge protection device that is specifically labeled as having surge

protection, an uninterruptible power supply (UPS), or a similar device. If the

computer has a television tuner, or a modem or telephone connection, protect

the computer by using surge protection with these signal inputs as well.

Connect the television cable or the telephone line cord to the surge protection

device, and then connect the device to the computer.

3. Download and install operating system updates.

a. Find out what operating system and version your computer is currently

running.

(Click Start > Control Panel and double-click System. The operating

system and version are shown under Windows edition.)

b. Open your internet browser and go to

http://www.hp.com/go/

contactHP.

c. Select your country and language, if necessary, and click Support &

Drivers.

HP OMNI100 Quick Setup Guide

Other manuals for HP OMNI100