Quick Start Guide
59
Filename: sb3usqs.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: JimL Last Saved By: kimt
Revision #: 159 Page: 59 of 134 Printed: 01/14/03 09:36 AM
Common Tasks
The upper card slot accepts:
■
CompactFlash
™
type I media
■
CompactFlash type II media
■
IBM Microdrive disk drive
The lower card slot accepts:
■
Secure Digital (SD) Memory Card
■
MultiMediaCard (MMC)
■
Memory Stick
®
(MS) Memory Card
■
SmartMedia
™
(SM) Memory Card
Special note about the
Safely Remove Hardware Utility
Warning:
Do not click Stop in the
Safely Remove Hardware window with
the USB Mass Storage Device selected.
Doing so removes the operating system
recognition of the 6-In-1 memory card
reader from your PC; you must restart
the PC to see your reader again.
If you open the Safely Remove Hardware
window by mistake, click Close.
To use the 6-In-1
memory card reader
Important: CompactFlash and Microdrive are keyed
and cannot be inserted incorrectly. Insert the
receptacle edge (holes) of this media into the
upper slot.
The Secure Digital (SD) card, the MultiMediaCard
(MMC), and the Memory Stick (MS) card must be
inserted upside down (gold connector fingers face
up). Note the direction of the notched corner on
the media.
1 Insert the media into the card slot until it stops.
The in-use light (A) on the card reader lights,
and the PC automatically detects the media.
2 The PC opens a window so you can access
the media contents. You can copy files from
or to the media.