hp dvd writer
15
About recording with HP DLA
HP DLA allows you to use the hp dvd writer drive
like a diskette drive by using the drag-and-drop
capability. When using HP DLA to copy files
directly to CDs or DVDs, you need to format the
disc first. After you format the disc and record
your files, you can make the disc compatible so it
can be read from other computers.
To format a disc that allows you to record files
using the DLA program:
1 Press the Eject button on the hp dvd writer
drive, and insert the blank CD-R, CD-RW,
DVD+R, or DVD+RW disc.
2 Click Start, and then click My Computer.
3 Right-click the dvd writer drive icon, and
select Format.
4 Under Volume Label, type in the title of
the disc.
5 Under Format type, select Full or Quick
(erase). You must select the quick format for
all CD-R and DVD+R discs. You must select the
full format for a CD-RW or DVD+RW disc the
first time you format. Full format can take up to
25 to 45 minutes, depending on the speed of
the drive and the size of your disc. Quick
format usually takes less than a minute.
6 If desired, click Enable Compression.
(Only PCs with DLA software installed
can read files formatted with this type of
compression.) If the files are already
compressed, DLA cannot compress them
again.
Important:
CD-R discs that contain compressed files
cannot be made compatible.
7 Click Start to format the disc.
8 Click Yes to the message that all files
on the CD or DVD will be erased.
To Next Page
Loading...
Need help?
General