6-9
Switch Memory and Configuration
Using the Menu and Web Browser Interfaces To Implement Configuration Changes
Note The only exception to this operation are two VLAN-related parameter changes
that require a reboot—described under “Rebooting To Activate Configuration
Changes” on page 6-11.
Using Save and Cancel in the Menu Interface
For any configuration screen in the menu interface, the Save command:
1. Implements the changes in the running-config file.
2. Saves your changes to the startup-config file.
If you decide not to save and implement the changes in the screen, select
Cancel to discard them and continue switch operation with the current oper-
ation. For example, suppose you have made the changes shown below in the
System Information screen:
Figure 6-4. Example of Pending Configuration Changes that Can Be Saved or
Cancelled
To save and
implement the
changes for all
parameters in this
screen, press the
[Enter] key, then
press
[S] (for Save).
To cancel all
changes, press the
[Enter] key, then
press
[C] (for Cancel)
To Next Page
Loading...
Need help?
General