EasyManuals Logo
Home>HP>Switch>ProCurve 2510-48

HP ProCurve 2510-48 User Manual

HP ProCurve 2510-48
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #230 background imageLoading...
Page #230 background image
11-24
Port Trunking
Port Status and Configuration
Outbound Traffic Distribution Across Trunked Links
Both trunk group options (LACP and Trunk) use source-destination address
pairs (SA/DA) for distributing outbound traffic over trunked links.
SA/DA (source address/destination address) causes the switch to distribute
outbound traffic to the links within the trunk group on the basis of source/
destination address pairs. That is, the switch sends traffic from the same
source address to the same destination address through the same trunked link,
and sends traffic from the same source address to a different destination
address through a different link, depending on the rotation of path assign-
ments among the links in the trunk. Likewise, the switch distributes traffic for
the same destination address but from different source addresses through
different links. Because the amount of traffic coming from or going to various
nodes in a network can vary widely, it is possible for one link in a trunk group
to be fully utilized while others in the same trunk have unused bandwidth
capacity even though the address assignments are evenly distributed across
the links in a trunk. In actual networking environments, this is rarely a
problem. However, if it becomes a problem, you can use the ProCurve Man-
ager Plus network management software to quickly and easily identify the
sources of heavy traffic (top talkers) and make adjustments to improve
performance.
Broadcasts, multicasts, and floods from different source addresses are dis-
tributed evenly across the links. As links are added or deleted, the switch
redistributes traffic across the trunk group. For example, in figure 11-10
showing a three-port trunk, traffic could be assigned as shown in table 11-6.
Interface Option Dynamic LACP
Trunk Group
Static LACP
Trunk Group
Static Non-Protocol
Trunk Group
Menu Interface No Yes Yes
CLI:
show trunks No Yes Yes
show interfaces No Yes Yes
show lacp Yes Yes No
show spanning-tree No Yes Yes
show igmp No Yes Yes
show config No Yes Yes

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2510-48 and is the answer not in the manual?

HP ProCurve 2510-48 Specifications

General IconGeneral
BrandHP
ModelProCurve 2510-48
CategorySwitch
LanguageEnglish

Related product manuals